[Answered] If wrought iron or a very low carbon steel (.10 percent carbon) is quenched from a red heat about ...

This topic contains a solution. Click here to go to the answer

Author Question: If wrought iron or a very low carbon steel (.10 percent carbon) is quenched from a red heat about ... (Read 97 times)

CBme

Hero Member
Posts: 548

on: Jul 26, 2018

If wrought iron or a very low carbon steel (.10 percent carbon) is quenched from a red heat about 1500 F. (815 C.), it will:

A) Remain soft B) Crack or split
C) Need to be tempered D) Get hard

Question 2

An out of alignment condition will cause a taper.

Indicate whether the statement is true or false

Need homework help now?

Ask unlimited questions for free

Ask a Question

Marked as best answer by a Subject Expert

Kimmy

Sr. Member
Posts: 342

Reply #1 on: Jul 26, 2018

Answer to Question 1

A

Answer to Question 2

TRUE

CBme

Member
Posts: 548

Reply 2 on: Jul 26, 2018

TYSM

JCABRERA33

Member
Posts: 344

Reply 3 on: Yesterday

Thanks for the timely response, appreciate it

« previous next »

Did you know?

Methicillin-resistant Staphylococcus aureus or MRSA was discovered in 1961 in the United Kingdom. It if often referred to as a superbug. MRSA infections cause more deaths in the United States every year than AIDS.

Did you know?

Cutaneous mucormycosis is a rare fungal infection that has been fatal in at least 29% of cases, and in as many as 83% of cases, depending on the patient's health prior to infection. It has occurred often after natural disasters such as tornados, and early treatment is essential.

Did you know?

If you could remove all of your skin, it would weigh up to 5 pounds.

Did you know?

Intradermal injections are somewhat difficult to correctly administer because the skin layers are so thin that it is easy to accidentally punch through to the deeper subcutaneous layer.

Did you know?

Patients who cannot swallow may receive nutrition via a parenteral route—usually, a catheter is inserted through the chest into a large vein going into the heart.