« previous next »

Author Question: Two eight input multiplexers can combine to send data over a single output line. The first step is ... (Read 98 times)

lilldybug07

  • Hero Member
  • *****
  • Posts: 546
on: Jul 27, 2018
Two eight input multiplexers can combine to send data over a single output line. The first step is combining select inputs. To complete the circuit:
 
  A) a NOR gate must tie output lines together.
  B) connect one enable input to the other via and inverter, then connect outputs together through an OR gate.
  C) the enable inputs must be connected together.
  D) tie enables inputs together and install a NAND gate on the outputs.

Question 2

Which CMOS series has both pin and electrical compatibility with its TTL counterpart?
 
  A) HCT B) AC C) HC D) ACT


cuttiesgirl16

  • Sr. Member
  • ****
  • Posts: 345
Reply #1 on: Jul 27, 2018
Answer to Question 1

B

Answer to Question 2

A


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
« previous next »
 

Did you know?

There are 60,000 miles of blood vessels in every adult human.

Did you know?

The first war in which wide-scale use of anesthetics occurred was the Civil War, and 80% of all wounds were in the extremities.

Did you know?

The immune system needs 9.5 hours of sleep in total darkness to recharge completely.

Did you know?

Your skin wrinkles if you stay in the bathtub a long time because the outermost layer of skin (which consists of dead keratin) swells when it absorbs water. It is tightly attached to the skin below it, so it compensates for the increased area by wrinkling. This happens to the hands and feet because they have the thickest layer of dead keratin cells.

Did you know?

Recent studies have shown that the number of medication errors increases in relation to the number of orders that are verified per pharmacist, per work shift.

First Line of Defence First Line of Defence
Births to Single Mothers Births to Single Mothers
The output on this alternator is printed on a label. The output on this alternator is printed on a label.
Looking carefully at the scan tool data is very helpful in locating the source of a problem. Looking carefully at the scan tool data is very helpful in locating the source of a problem.
Western blot. In the first step, (1) a polyacrylamide gel electrophoresis is performed to separate ... Western blot. In the first step, (1) a polyacrylamide gel electrophoresis is performed to separate ...
OraQuick. A negative result would show a red line at the "C" mark, whereas a positive ... OraQuick. A negative result would show a red line at the "C" mark, whereas a positive ...
Video: Carbohydrate Metabolism: Introduction to renal processes and filtrate formation and composition

For a complete list of videos, visit our video library