« previous next »

Author Question: When a load is applied to a potentiometer, the voltage across a load connected to the wiper arm is ... (Read 138 times)

DyllonKazuo

  • Hero Member
  • *****
  • Posts: 565
on: Jul 28, 2018
When a load is applied to a potentiometer, the voltage across a load connected to the wiper arm is determined solely by the potentiometer.
 
  Indicate whether the statement is true or false

Question 2

If the RT = 6.8 k and R1 = 10 k in a two-branch parallel circuit, what is the value of R2?
 
  A) 12 k B) 3.2 k C) 16.8 k D) 21.3 k


lin77x

  • Sr. Member
  • ****
  • Posts: 326
Reply #1 on: Jul 28, 2018
Answer to Question 1

FALSE

Answer to Question 2

D


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
« previous next »
 

Did you know?

Elderly adults are at greatest risk of stroke and myocardial infarction and have the most to gain from prophylaxis. Patients ages 60 to 80 years with blood pressures above 160/90 mm Hg should benefit from antihypertensive treatment.

Did you know?

Limit intake of red meat and dairy products made with whole milk. Choose skim milk, low-fat or fat-free dairy products. Limit fried food. Use healthy oils when cooking.

Did you know?

The training of an anesthesiologist typically requires four years of college, 4 years of medical school, 1 year of internship, and 3 years of residency.

Did you know?

Alcohol acts as a diuretic. Eight ounces of water is needed to metabolize just 1 ounce of alcohol.

Did you know?

In inpatient settings, adverse drug events account for an estimated one in three of all hospital adverse events. They affect approximately 2 million hospital stays every year, and prolong hospital stays by between one and five days.

Transdermal patch administration: (b) patch immediately applied to clean, dry, hairless skin and lab Transdermal patch administration: (b) patch immediately applied to clean, dry, hairless skin and lab
The oil pressure switch is connected to a warning lamp that alerts the driver of low oil pressure. The oil pressure switch is connected to a warning lamp that alerts the driver of low oil pressure.
A typical battery load tester hookup. A typical battery load tester hookup.
A typical output driver. In this case, the PCM applies voltage to the fuel pump relay coil to ... A typical output driver. In this case, the PCM applies voltage to the fuel pump relay coil to ...
To check for voltage at terminal 30, use a test light or a voltmeter. Start by connecting the ... To check for voltage at terminal 30, use a test light or a voltmeter. Start by connecting the ...
How much voltage does the resistor drop in Figure 10-2? a. 59 mV b. 19.94 V c. 20 V d. 10 V How much voltage does the resistor drop in Figure 10-2? a. 59 mV b. 19.94 V c. 20 V d. 10 V
Video: Glucose anabolism reactions: Glycogenolysis and Gluconeogenesis

For a complete list of videos, visit our video library