« previous next »

Author Question: While troubleshooting a circuit the voltage seems to be zero; what if any adjustment should be ... (Read 102 times)

Hungry!

  • Hero Member
  • *****
  • Posts: 1,071
on: Jul 28, 2018
While troubleshooting a circuit the voltage seems to be zero; what if any adjustment should be checked on the oscilloscope?
 
  A) focus setting B) AC/GND/DC switch
  C) time division setting D) trigger level

Question 2

Superimposing an AC voltage of 3.54 Vrms with a DC source of 10 V results in a waveform that:
 
  A) peaks at 20 V. B) peaks at 13.54 V. C) peaks at 15 V. D) both B and C


brittiany.barnes

  • Sr. Member
  • ****
  • Posts: 321
Reply #1 on: Jul 28, 2018
Answer to Question 1

B

Answer to Question 2

C


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
« previous next »
 

Did you know?

The first oncogene was discovered in 1970 and was termed SRC (pronounced "SARK").

Did you know?

It is believed that humans initially contracted crabs from gorillas about 3 million years ago from either sleeping in gorilla nests or eating the apes.

Did you know?

Everyone has one nostril that is larger than the other.

Did you know?

The first oral chemotherapy drug for colon cancer was approved by FDA in 2001.

Did you know?

The average person is easily confused by the terms pharmaceutics and pharmacology, thinking they are one and the same. Whereas pharmaceutics is the science of preparing and dispensing drugs (otherwise known as the science of pharmacy), pharmacology is the study of medications.

A variable valve timing solenoid being controlled by applying voltage from the PCM. A variable valve timing solenoid being controlled by applying voltage from the PCM.
Voltmeter showing the battery voltage when the headlights were on (engine off) for one minute. Voltmeter showing the battery voltage when the headlights were on (engine off) for one minute.
The varying voltage signal from the pickup coil triggers the ignition module. The ignition module ... The varying voltage signal from the pickup coil triggers the ignition module. The ignition module ...
The signal voltage from a throttle position increases as the throttle is opened because the wiper ... The signal voltage from a throttle position increases as the throttle is opened because the wiper ...
How much voltage does the resistor drop in Figure 10-2? a. 59 mV b. 19.94 V c. 20 V d. 10 V How much voltage does the resistor drop in Figure 10-2? a. 59 mV b. 19.94 V c. 20 V d. 10 V
During a period of high power demand, the voltage output of the power company is reduced by ... During a period of high power demand, the voltage output of the power company is reduced by ...
Video: Cytotoxic T cell receptors, activation, proliferation, differentiation & action

For a complete list of videos, visit our video library