Author Question: Which of the following describes the basic operation of a single-slope A/D converter? A) The ... (Read 64 times)

Shelles · **on:** Jul 28, 2018

Which of the following describes the basic operation of a single-slope A/D converter?

A) The input voltage is used to set the frequency of a voltage-controlled oscillator (VCO). The VCO quits changing frequency when the input voltage stabilizes. The frequency of the VCO, which is proportional to the analog input voltage, is measured and is displayed on the digital display as a voltage reading.
B) A ramp voltage and analog input voltage are applied to a comparator. As the input voltage causes the integrating capacitor to charge, it will at some point equal the ramp voltage. The ramp voltage is measured and displayed on the digital panel meter.
C) A ramp generator is used to enable a counter through a comparator. When the ramp voltage equals the input voltage the counter is latched and then reset. The counter reading is proportional to the input voltage since the ramp is changing at a constant V/second rate.
D) Any of the above could be correct, depending on the specific type of A/D converter involved.

Question 2

A pulse-triggered flip-flop is identified by a bubble on its Q output terminal.

Indicate whether the statement is true or false