This topic contains a solution. Click here to go to the answer
« previous next »

Author Question: The dropout voltage rating of a particular 12-V IC regulator is 2.5 V. What does this mean? A) ... (Read 67 times)

NClaborn

  • Hero Member
  • *****
  • Posts: 560
on: Jul 28, 2018
The dropout voltage rating of a particular 12-V IC regulator is 2.5 V. What does this mean?
 
  A) The rated input voltage is 2.5 V.
  B) The output voltage is always 2.5 V less than the input voltage.
  C) The circuit loses regulation when the input voltage falls below 14.5 V.
  D) The circuit loses regulation when the input voltage rises above 14.5 V.

Question 2

If one input of an OR gate is HIGH while the other is a clock signal, the output is
 
  A) LOW. B) a clock signal.
  C) HIGH. D) cannot be determined


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

gcook

  • Sr. Member
  • ****
  • Posts: 343
Reply #1 on: Jul 28, 2018
Answer to Question 1

C

Answer to Question 2

C


NClaborn

  • Member
  • Posts: 560
Reply 2 on: Jul 28, 2018
Great answer, keep it coming :)

bitingbit

  • Member
  • Posts: 323
Reply 3 on: Yesterday
Thanks for the timely response, appreciate it

« previous next »
 

Did you know?

Approximately one in four people diagnosed with diabetes will develop foot problems. Of these, about one-third will require lower extremity amputation.

Did you know?

Certain topical medications such as clotrimazole and betamethasone are not approved for use in children younger than 12 years of age. They must be used very cautiously, as directed by a doctor, to treat any child. Children have a much greater response to topical steroid medications.

Did you know?

Signs and symptoms of a drug overdose include losing consciousness, fever or sweating, breathing problems, abnormal pulse, and changes in skin color.

Did you know?

For pediatric patients, intravenous fluids are the most commonly cited products involved in medication errors that are reported to the USP.

Did you know?

For about 100 years, scientists thought that peptic ulcers were caused by stress, spicy food, and alcohol. Later, researchers added stomach acid to the list of causes and began treating ulcers with antacids. Now it is known that peptic ulcers are predominantly caused by Helicobacter pylori, a spiral-shaped bacterium that normally exist in the stomach.

This battery shows a large “1000” on the front panel but this is the CA rating and not the ... This battery shows a large “1000” on the front panel but this is the CA rating and not the ...
Using the voltmeter leads from a starting and charging test unit to measure the voltage drop ... Using the voltmeter leads from a starting and charging test unit to measure the voltage drop ...
Checking the voltage drop between the TP sensor ground and a good engine ground with the ignition ... Checking the voltage drop between the TP sensor ground and a good engine ground with the ignition ...
When the O2S voltage rises above 450 mV, the PCM starts to control the fuel mixture based on ... When the O2S voltage rises above 450 mV, the PCM starts to control the fuel mixture based on ...
A lack of fuel flow could be due to a restricted fuel-pressure regulator. Notice the fine screen ... A lack of fuel flow could be due to a restricted fuel-pressure regulator. Notice the fine screen ...
Find the voltage, current and power for each resistor in the circuit below Find the voltage, current and power for each resistor in the circuit below
Video: Contraction and Relaxation Animation

For a complete list of videos, visit our video library