Answer to Question 1
Modulus will likely increase by adding most common fillers. The reasons are that the filler is itself a stiff material. Secondly, the filler will likely fill into the spaces between the molecules and thus inhibit the molecules from moving over each other. This resistance to intermolecular motion is seen as an increase in modulus.
Answer to Question 2
One of the important aspects of impact toughness is the tendency of the material to fail through cracking. Cracks often begin at sharp locations as is created when a notch is installed in the part. Therefore, a key reason to notch the sample is to determine the tendency to fail by cracking. Another, perhaps equally important reason, is to provide a point at which failure is likely to occur so that the failure values from one test to another will be less dependent on the initiation of the failure and more dependent on the crack propagation through the material.
Effect of pH on oxygen binding to hemoglobin
First-pass effect: (a) drugs are absorbed; (b) drugs enter hepatic portal circulation and go directl
Habituation to the Aversive Effect of the Odor of Pups
The Greenhouse Effect: Influences on Temperature
The Serial-Position Effect
Adding tens SK