Emerging Dock Company manufactures boat docks on an assembly line. Its standard costing system uses two cost categories, direct materials and conversion costs. Each product must pass through the Assembly Department and the Finishing Department. Direct materials are added at the beginning of the production process. Conversion costs are allocated evenly throughout production.
Data for the Assembly Department for May 2017 are:
| Work in process, beginning inventory: | 82 units |
Direct materials (100% complete)
Conversion costs (30% complete)
| Units started during May | 48 units |
| Work in process, ending inventory: | 22 units |
Direct materials (100% complete)
Conversion costs (50% complete)
Costs for May:
Standard costs for Assembly:
| Direct materials | $12,000 per unit |
| Conversion costs | $33,000 per unit |
Work in process, beginning inventory:
Which of the following journal entries records the standard costs of direct materials assigned to units worked on and total direct materials variances assuming that the Assembly Department used 15% less materials than expected?
◦
| Work in Process - Assembly | 576,000 |
| Assembly Department Materials Cost Control | 576,000 |
◦
| Work in Process - Assembly | 576,000 |
| Direct Materials Variance | 86,400 |
| Assembly Department Materials Cost Control | 489,600 |
◦
| Work in Process - Assembly | 86,400 |
| Assembly Department Materials Cost Control | 86,400 |
◦
| Work in Process - Assembly | 489,600 |
| Direct Materials Variances | 86,400 |
| Assembly Department Materials Cost Control | 576,000 |
Injecting an IV push (bolus) medication; B, into a primary infusion line
Johannes Gutenberg, Page from the Forty-Two-Line Bible, Mainz.
Components of the nervous system.
The end of a typical line wrench, which shows that it is capable of grasping most of the head of ...
The anterolateral system. The pathways from only one side of the body are shown.
Sensory systems and Endocrine system