This topic contains a solution. Click here to go to the answer
« previous next »

Author Question: For a VLAN SVI to be in the up/up state, which option isnotrequired? (Read 113 times)

kaid0807

  • Hero Member
  • *****
  • Posts: 515
on: Nov 24, 2021

Question 1

You need to configure a default route. Which of the following commands is the correct way to set the default route out of your network?
◦ ip route 0.0.0.0.0.0.0.0 172.20.3.2
◦ ip route 0.0.0.0 0.0.0.0 172.20.3.2
◦ ip route 0.0.0.0 172.20.3.2
◦ ip route any 172.20.3.2

Question 2

For a VLAN SVI to be in the up/up state, which option is not required?
◦ The VLAN must be defined locally.
◦ The VLAN must have an entry in the MAC address table.
◦ An access link or trunk must be configured and optional in the VLAN (not blocked or pruned).
◦ The VLAN SVI must be enabled.
Official Cert Guide: CCNA 200-301 ¦ Odom ¦ 1st Edition
Buy Test-Bank


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by kaid0807 on Nov 24, 2021

sokh

  • Sr. Member
  • ****
  • Posts: 357
Reply #1 on: Nov 24, 2021
Lorsum iprem. Lorsus sur ipci. Lorsem sur iprem. Lorsum sur ipdi, lorsem sur ipci. Lorsum sur iprium, valum sur ipci et, vala sur ipci. Lorsem sur ipci, lorsa sur iprem. Valus sur ipdi. Lorsus sur iprium nunc, valem sur iprium. Valem sur ipdi. Lorsa sur iprium. Lorsum sur iprium. Valem sur ipdi. Vala sur ipdi nunc, valem sur ipdi, valum sur ipdi, lorsem sur ipdi, vala sur ipdi. Valem sur iprem nunc, lorsa sur iprium. Valum sur ipdi et, lorsus sur ipci. Valem sur iprem. Valem sur ipci. Lorsa sur iprium. Lorsem sur ipci, valus sur iprem. Lorsem sur iprem nunc, valus sur iprium.
Answer Preview
Only 49% of students answer this correctly


kaid0807

  • Member
  • Posts: 515
Reply 2 on: Nov 24, 2021
Thanks for the timely response, appreciate it

ASDFGJLO

  • Member
  • Posts: 335
Reply 3 on: Yesterday
:D TYSM

« previous next »
 

Did you know?

Increased intake of vitamin D has been shown to reduce fractures up to 25% in older people.

Did you know?

ACTH levels are normally highest in the early morning (between 6 and 8 A.M.) and lowest in the evening (between 6 and 11 P.M.). Therefore, a doctor who suspects abnormal levels looks for low ACTH in the morning and high ACTH in the evening.

Did you know?

People with alcoholism are at a much greater risk of malnutrition than are other people and usually exhibit low levels of most vitamins (especially folic acid). This is because alcohol often takes the place of 50% of their daily intake of calories, with little nutritional value contained in it.

Did you know?

The largest baby ever born weighed more than 23 pounds but died just 11 hours after his birth in 1879. The largest surviving baby was born in October 2009 in Sumatra, Indonesia, and weighed an astounding 19.2 pounds at birth.

Did you know?

Warfarin was developed as a consequence of the study of a strange bleeding disorder that suddenly occurred in cattle on the northern prairies of the United States in the early 1900s.

The structural formulas show the state of ionization that would predominate at pH 7.0 The structural formulas show the state of ionization that would predominate at pH 7.0
The Scopes Trial: William Jennings Bryan (right) represented the state of Tennessee, and Clarence Da The Scopes Trial: William Jennings Bryan (right) represented the state of Tennessee, and Clarence Da
In countries where water can be contaminated, breastfeeding is an important option for the health of ... In countries where water can be contaminated, breastfeeding is an important option for the health of ...
Drug elimination: half-life to steady state. Drug elimination: half-life to steady state.
Fixed bed state (i) and complete fluidization (ii) Fixed bed state (i) and complete fluidization (ii)
The steady state in enzyme kinetics The steady state in enzyme kinetics
Video: HIV Infection: Viral life cycle

For a complete list of videos, visit our video library