Two technicians are discussing a stepped ECT circuit. Technician A says that the sensor used for a stepped circuit is different than one used in a non-stepped circuit. Technician B says that a stepped ECT circuit uses different internal resistance inside the PCM. Which technician is correct?
A) Technician A only B) Technician B only
C) Both technicians D) Neither technician
Question 2
When diagnosing an electronic distributor ignition system, a 12-volt test light connected from the negative primary coil terminal to ground flutters while cranking the engine. A test spark tester does not fire when it is connected from the coil secondary wire to ground while cranking the engine. The cause of this problem could be a ________.
A) Defective ignition coil B) Defective primary circuit
C) Defective ignition module D) Defective pickup coil
The technician is using a feeler gauge that is onethousandth of an inch thinner and another ...
Voltmeter hook-ups for voltage-drop testing of a GM-type cranking circuit.
The relationship between the crankshaft position (CKP) sensor and the camshaft position (CMP) sensor ...
When the exhaust is lean, the output of a zirconia oxygen sensor is below 450 mV.
Testing an oxygen sensor using a DMM set on DC volts. With the engine operating in closed loop, ...
A typical accelerator pedal position (APP) sensor, showing two different output voltage signals ...