Two technicians are discussing a stepped ECT circuit. Technician A says that the sensor used for a stepped circuit is different than one used in a non-stepped circuit. Technician B says that a stepped ECT circuit uses different internal resistance inside the PCM. Which technician is correct?
A) Technician A only B) Technician B only
C) Both technicians D) Neither technician
Question 2
When diagnosing an electronic distributor ignition system, a 12-volt test light connected from the negative primary coil terminal to ground flutters while cranking the engine. A test spark tester does not fire when it is connected from the coil secondary wire to ground while cranking the engine. The cause of this problem could be a ________.
A) Defective ignition coil B) Defective primary circuit
C) Defective ignition module D) Defective pickup coil
A typical accelerator pedal position (APP) sensor uses three different sensors in one package with ...
A typical zirconia oxygen sensor.
Adding propane to the air inlet of an engine operating in closed loop with a working oxygen sensor ...
When the engine is cold and before the oxygen sensor is hot enough to achieve closed-loop, the ...
Use Fleury’s algorithm to determine Euler Circuit in the following graph. Exhibit exactly one ...
The Pulmonary Circuit