Two technicians are discussing a stepped ECT circuit. Technician A says that the sensor used for a stepped circuit is different than one used in a non-stepped circuit. Technician B says that a stepped ECT circuit uses different internal resistance inside the PCM. Which technician is correct?
A) Technician A only B) Technician B only
C) Both technicians D) Neither technician
Question 2
When diagnosing an electronic distributor ignition system, a 12-volt test light connected from the negative primary coil terminal to ground flutters while cranking the engine. A test spark tester does not fire when it is connected from the coil secondary wire to ground while cranking the engine. The cause of this problem could be a ________.
A) Defective ignition coil B) Defective primary circuit
C) Defective ignition module D) Defective pickup coil
The nurse applies a pulse oximeter sensor on the client’s finger.
A typical beginning technician tool set that includes the basic tools to get started.
A typical two-step ECT circuit showing that when the coolant temperature is low, the PCM applies a ...
Altitude affects the MAP sensor voltage.
When the propane is shut off, the oxygen sensor should read below 200 mV.
The muscle-spindle feedback circuit