Two technicians are discussing a stepped ECT circuit. Technician A says that the sensor used for a stepped circuit is different than one used in a non-stepped circuit. Technician B says that a stepped ECT circuit uses different internal resistance inside the PCM. Which technician is correct?
A) Technician A only B) Technician B only
C) Both technicians D) Neither technician
Question 2
When diagnosing an electronic distributor ignition system, a 12-volt test light connected from the negative primary coil terminal to ground flutters while cranking the engine. A test spark tester does not fire when it is connected from the coil secondary wire to ground while cranking the engine. The cause of this problem could be a ________.
A) Defective ignition coil B) Defective primary circuit
C) Defective ignition module D) Defective pickup coil
A typical accelerator pedal position (APP) sensor uses three different sensors in one package with ...
A typical engine coolant temperature (ECT) sensor. ECT sensors are located near the thermostat ...
A plastic MAP sensor used for training purposes showing the electronic circuit board and electrical ...
A typical air vane sensor with the cover removed. The movable arm contacts a carbon resistance path ...
An H-bridge circuit is used to control the direction of the DC electric motor of the electronic ...
Pharmacology for Canadian Pharmacy Technicians