Skills and Trades

____________________ is the most important key to a long life for the CV joint.

Started by bcretired

Which type of drive axle supports the weight of the vehicle?

Started by bb

Which statement best describes the hypoid gear?

Started by Collmarie

Which statement best describes the double-Cardan universal joint?

Started by tsand2

Which of the following should be done first while performing a CV joint inspection?

Started by leilurhhh

Which final drive component must rotate at the same speed as the ring gear?

Started by azncindy619

What type of gearset has 9 drive pinion teeth and 37 ring gear teeth?

Started by silviawilliams41

What should be done to centre the tooth contact pattern if the pattern is currently high on the ring ...

Started by brutforce

What is the purpose of using cancelling angles with a driveshaft equipped with universal joints?

Started by aabwk4

What is the purpose of a slip yoke?

Started by rayancarla1

The vehicle produces a noise that remains constant while accelerating, decelerating, or coasting at ...

Started by roselinechinyere27m

How much plunge can the cross-groove joint handle?

Started by sabina

How does axle-bearing noise differ from differential noise?

Started by rayancarla1

What two conditions are usually the first symptoms to be noticed when a differential or drive axle ...

Started by Pineappleeh

Name the three ways in which CV joints can be classified.

Started by tnt_battle

Identify the basic internal components within a fixed ball-type CV joint.

Started by frankwu

Describe how to measure ring and pinion gearset backlash.

Started by abarnes

To provide an even wear pattern, the synchronizer sleeve should be assembled onto the hub in a new position.

Started by craiczarry

Some manual transmissions/transaxles have a dipstick to check the fluid level.

Started by CORALGRILL2014

Manual transmission/transaxle internal shift linkage should be adjusted if a shift linkage problem ...

Started by londonang

Jumping out of gear can be caused by excessive clearance between gears and the input shaft or badly ...

Started by Hungry!

If a noise stops with the engine at idle and the clutch disengaged, the noise is probably coming ...

Started by student77

Some aluminum manual transmission/transaxle case cracks may be repaired with a(n) __________________ sealer.

Started by HCHenry

Prior to disassembling a manual transmission, measure the input and output shaft __________________ ...

Started by jasdeep_brar

If the vehicle has no dipstick, the transmission/transaxle fluid level may be checked through the ...

Started by saraeharris