Skills and Trades

Fluid leakage can be caused by an excessive amount of __________________ in the transmission or transaxle.

Started by ss2343

__________________ shifting may be caused by clutch linkage out of adjustment.

Started by londonang

Why do synchronizer blocking rings have machined grooves on their internal surfaces?

Started by Caiter2013

Which of the following may be reused when rebuilding a transmission?

Started by itsmyluck

What type of fluid is required by dual-clutch transmissions with wet clutches?

Started by jerry coleman

What should be inspected if a transmission/transaxle shows signs of fluid leakage out of a seal?

Started by asd123

What is the effect of using a lubricant that is too thick?

Started by frankwu

What could be the result of using too much grease on the front of the input shaft during ...

Started by vinney12

What component is unique to a transaxle and can also be serviced during disassembly?

Started by chads108

What can be used to remove gears and/or synchronizer assemblies from the transmission/transaxle shafts?

Started by Tirant22

List five maintenance checks that should be made during the visual inspection of ...

Started by jenna1

Identify three causes of hard shifting.

Started by formula1

How should the transmission be handled during installation?

Started by Pineappleeh

Transaxles are commonly used on rear-wheel-drive vehicles.

Started by nautica902

Fifth and sixth gears increase the number of gear ratios used for torque multiplication.

Started by Kikoku

Cars with a mid- or rear-mounted engine send power to the rear wheels through a transaxle.

Started by bcretired

A transmission or transaxle uses meshed gears of various sizes to give the engine a mechanical ...

Started by jessicacav

A gear ratio of less than 1:1 indicates overdrive.

Started by c0205847

Transmission gearing is located within an aluminum or iron casting called the transmission ...

Started by bobbie

In a RWD differential, the power flow changes ____________________ between the drive pinion gear and ...

Started by newyorker26

All gear changes pass through the ____________________ position.

Started by karlynnae

A DCT is really two separate manual transmissions, housed in the same case, that work ____________________.

Started by ashley

____________________ contain the transmission gearing, final drive and differential, and drive axle ...

Started by jc611

Which type of gear develops the problem of gear whine at higher speeds?

Started by Chloeellawright

Which of these gear ratios shows an overdrive condition?

Started by drink