Physics

. The equation for the output is VOUT (0.025 V)1n Refer to Figure 5. If the input is 3.0 V ...

Started by azncindy619

A log amplifier is used for

Started by audie

An OTA with a transconductance of 2000 S has a load resistance of 5 k. If the input voltage is 300 ...

Started by mwit1967

An OTA has

Started by MirandaLo

The circuit is a modulator for an audio signal.Refer to Figure 4. The input at Vin1 is the ...

Started by Hungry!

Refer to Figure 3. This purpose of R3 is to adjust the

Started by stevenposner

Assume the bias current is 125 A and gm = 16 S/A.Refer to Figure 2. If the power supplies ...

Started by Wadzanai

Assume the bias current is 125 A and gm = 16 S/A.Refer to Figure 2. The voltage gain is

Started by jlmhmf

The amount of bias current for an OTA changes the

Started by james0929

A capacitively coupled isolation amplifierRefer to Figure 1. The box with the ? represents a

Started by ENagel

An ISO124 isolation amplifier has an internal oscillator of 500 kHz. The oscillator signal

Started by dakota nelson

The output signal from an isolation amplifier is a

Started by luvbio

To avoid very large capacitors in a capacitively coupled isolation amplifier, the amplifier can use

Started by Wadzanai

Isolation amplifiers can isolate the input and output by

Started by james9437

Assume there is a phase shift between two common-mode signals. This can

Started by jon_i

An excellent way to reduce leakage current on the input lines is to

Started by Sportsfan2111

The purpose of guarding with an instrumentation amplifier is to

Started by Alainaaa8

A typical application for an instrumentation amplifier is

Started by Zoey63294

The bandwidth of a typical instrumentation amplifier is

Started by NClaborn

Audio power amplifiers typically have a bandwidth from 3 kHz to 30 kHz.

Started by Bernana

The logarithm of a number is the power to which a base is raised to obtain the number.

Started by Mr.Thesaxman

An OTA is often used to isolate a sensitive input from high voltage.

Started by K@

An OTA is a current-to-voltage amplifier.

Started by KWilfred

An isolation amplifier requires two separate power supplies.

Started by fnuegbu

The classic three-op-amp instrumentation amplifier will have a differential gain of 1 if RG is not connected.

Started by cagreen833