Two technicians are discussing a stepped ECT circuit. Technician A says that the sensor used for a stepped circuit is different than one used in a non-stepped circuit. Technician B says that a stepped ECT circuit uses different internal resistance inside the PCM. Which technician is correct?
A) Technician A only B) Technician B only
C) Both technicians D) Neither technician
Question 2
When diagnosing an electronic distributor ignition system, a 12-volt test light connected from the negative primary coil terminal to ground flutters while cranking the engine. A test spark tester does not fire when it is connected from the coil secondary wire to ground while cranking the engine. The cause of this problem could be a ________.
A) Defective ignition coil B) Defective primary circuit
C) Defective ignition module D) Defective pickup coil
Pulse oximetry with the sensor probe applied securely, flush with skin, making sure that both sensor
A Hall-effect sensor produces a digital on-off voltage signal whether it is used with a blade or a ...
A magnetic sensor uses a permanent magnet surrounded by a coil of wire. The notches of the ...
When the exhaust is rich, the output of a zirconia oxygen sensor is above 450 mV.
Use a DMM set to read DC volts to check the voltage drop of the positive circuit to the fuel ...
For the circuit in Figure 1, assume ideal diodes. The peak inverse voltage is approximately