Technician A says oil that pressure should be tested before installation of the engine in the vehicle. Technician B says that some cylinder heads use the torque-to-yield method, where the head bolts are tightened to a specified torque and then rotated an additional specified number of degrees. Who is right?
A) Technician A only B) Technician B only
C) Both technicians A and B D) Neither technician A nor B
Question 2
If the bell housing is not properly torqued to the engine block, ________.
A) The rear cylinder can be distorted (become out-of-round)
B) The crankshaft will crack
C) The bell housing will distort
D) The engine block will crack
The pressure cap should be checked for proper operation using a pressure tester as part of the ...
If a cylinder(s) is lower than most of the others, use an oil can and use two squirts of engine oil ...
Some plastic intake manifolds are equipped with a pressure relief valve that would open in the ...
Checking the voltage drop between the TP sensor ground and a good engine ground with the ignition ...
Nonlinear increase in saturation vapor pressure with increase in temperature.
Blood pressure measurements: Palpable blood pressure