Technician A says oil that pressure should be tested before installation of the engine in the vehicle. Technician B says that some cylinder heads use the torque-to-yield method, where the head bolts are tightened to a specified torque and then rotated an additional specified number of degrees. Who is right?
A) Technician A only B) Technician B only
C) Both technicians A and B D) Neither technician A nor B
Question 2
If the bell housing is not properly torqued to the engine block, ________.
A) The rear cylinder can be distorted (become out-of-round)
B) The crankshaft will crack
C) The bell housing will distort
D) The engine block will crack
Classification of blood pressure for adults age 18 and older
a) Using a fist to support thumb pressure b) Using thumb-beside-thumb pressure
An ECT sensor being tested using a digital meter set to DC volts. A chart showing the voltage ...
Lightly squeeze along each finger applying pressure first near the knuckle and then moving along the ...
Use of a hand tool to apply pressure to a trigger point.
Physics - Density and Pressure