Technician A says oil that pressure should be tested before installation of the engine in the vehicle. Technician B says that some cylinder heads use the torque-to-yield method, where the head bolts are tightened to a specified torque and then rotated an additional specified number of degrees. Who is right?
A) Technician A only B) Technician B only
C) Both technicians A and B D) Neither technician A nor B
Question 2
If the bell housing is not properly torqued to the engine block, ________.
A) The rear cylinder can be distorted (become out-of-round)
B) The crankshaft will crack
C) The bell housing will distort
D) The engine block will crack
Blood Pressure Classifications
The level in the coolant recovery system raises and lowers with engine temperature.
Weak valve springs will produce a normal reading at idle, but as engine speed increases, the needle ...
The engine is rotated until the timing marks on the front of the crankshaft line up with zero ...
Good hand and body mechanics when applying thumb pressure to the back.
Measuring Blood Pressure