This topic contains a solution. Click here to go to the answer
« previous next »

Author Question: If the tungsten electrode touches the filler metal during welding, the welder must _____. a. ... (Read 108 times)

segrsyd

  • Hero Member
  • *****
  • Posts: 530
on: Jul 24, 2018
If the tungsten electrode touches the filler metal during welding, the welder must _____.
 
  a. remove and clean the electrode
  b. discard the electrode
  c. increase the push angle
  d. touch the electrode to the weld puddle

Question 2

Another common name for lineman pliers is _____.
 
  a. locking pliers
  b. tongue-and-groove pliers
  c. needle-nose pliers
  d. side cutter


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

chereeb

  • Sr. Member
  • ****
  • Posts: 326
Reply #1 on: Jul 24, 2018
Answer to Question 1

a

Answer to Question 2

d


segrsyd

  • Member
  • Posts: 530
Reply 2 on: Jul 24, 2018
Excellent

kilada

  • Member
  • Posts: 311
Reply 3 on: Yesterday
YES! Correct, THANKS for helping me on my review

« previous next »
 

Did you know?

The heart is located in the center of the chest, with part of it tipped slightly so that it taps against the left side of the chest.

Did you know?

Blood in the urine can be a sign of a kidney stone, glomerulonephritis, or other kidney problems.

Did you know?

Patients should never assume they are being given the appropriate drugs. They should make sure they know which drugs are being prescribed, and always double-check that the drugs received match the prescription.

Did you know?

The largest baby ever born weighed more than 23 pounds but died just 11 hours after his birth in 1879. The largest surviving baby was born in October 2009 in Sumatra, Indonesia, and weighed an astounding 19.2 pounds at birth.

Did you know?

Elderly adults are at greatest risk of stroke and myocardial infarction and have the most to gain from prophylaxis. Patients ages 60 to 80 years with blood pressures above 160/90 mm Hg should benefit from antihypertensive treatment.

Tin snips are used to cut thin sheets of metal or carpet. Tin snips are used to cut thin sheets of metal or carpet.
A typical hacksaw that is used to cut metal. If cutting sheet metal or thin objects, then use a ... A typical hacksaw that is used to cut metal. If cutting sheet metal or thin objects, then use a ...
All oily shop cloths should be stored in a metal container equipped with a lid to help prevent ... All oily shop cloths should be stored in a metal container equipped with a lid to help prevent ...
A close-up showing the recessed center electrode on a spark tester. It is recessed 3/8 inch into ... A close-up showing the recessed center electrode on a spark tester. It is recessed 3/8 inch into ...
This five-wire mass air flow sensor consists of a metal foil sensing unit, an intake air temperature ... This five-wire mass air flow sensor consists of a metal foil sensing unit, an intake air temperature ...
If 1.823 g of cobalt metal reacts with 0.495 g of oxygen gas, what is the empiri If 1.823 g of cobalt metal reacts with 0.495 g of oxygen gas, what is the empiri
Video: Diversity of Living Creatures - Charles Darwin & the Beagle's Voyage

For a complete list of videos, visit our video library