This topic contains a solution. Click here to go to the answer
« previous next »

Author Question: If the tungsten electrode touches the filler metal during welding, the welder must _____. a. ... (Read 123 times)

segrsyd

  • Hero Member
  • *****
  • Posts: 530
on: Jul 24, 2018
If the tungsten electrode touches the filler metal during welding, the welder must _____.
 
  a. remove and clean the electrode
  b. discard the electrode
  c. increase the push angle
  d. touch the electrode to the weld puddle

Question 2

Another common name for lineman pliers is _____.
 
  a. locking pliers
  b. tongue-and-groove pliers
  c. needle-nose pliers
  d. side cutter


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

chereeb

  • Sr. Member
  • ****
  • Posts: 326
Reply #1 on: Jul 24, 2018
Answer to Question 1

a

Answer to Question 2

d


segrsyd

  • Member
  • Posts: 530
Reply 2 on: Jul 24, 2018
:D TYSM

ashely1112

  • Member
  • Posts: 347
Reply 3 on: Yesterday
Gracias!

« previous next »
 

Did you know?

The FDA recognizes 118 routes of administration.

Did you know?

ACTH levels are normally highest in the early morning (between 6 and 8 A.M.) and lowest in the evening (between 6 and 11 P.M.). Therefore, a doctor who suspects abnormal levels looks for low ACTH in the morning and high ACTH in the evening.

Did you know?

Since 1988, the CDC has reported a 99% reduction in bacterial meningitis caused by Haemophilus influenzae, due to the introduction of the vaccine against it.

Did you know?

Aspirin is the most widely used drug in the world. It has even been recognized as such by the Guinness Book of World Records.

Did you know?

Sildenafil (Viagra®) has two actions that may be of consequence in patients with heart disease. It can lower the blood pressure, and it can interact with nitrates. It should never be used in patients who are taking nitrates.

A typical hacksaw that is used to cut metal. If cutting sheet metal or thin objects, then use a ... A typical hacksaw that is used to cut metal. If cutting sheet metal or thin objects, then use a ...
All oily shop cloths should be stored in a metal container equipped with a lid to help prevent ... All oily shop cloths should be stored in a metal container equipped with a lid to help prevent ...
A normally worn spark plug that has a tapered platinum-tipped center electrode. A normally worn spark plug that has a tapered platinum-tipped center electrode.
A three-piece filler tube assembly. A three-piece filler tube assembly.
Some Ford metal line connections use springlocks and O-rings. Some Ford metal line connections use springlocks and O-rings.
Video: ribosome

For a complete list of videos, visit our video library