This topic contains a solution. Click here to go to the answer

Author Question: Why didn't you have to take separate measurements for the individual currents through resistors R1, ... (Read 12 times)

clmills979

  • Hero Member
  • *****
  • Posts: 551
Why didn't you have to take separate measurements for the individual currents through resistors R1, R2, and R3 in Procedures 2, 3, and 4?

Question 2

You charge a parallel-plate capacitor, remove it from the battery, and prevent the wires connected to the plates from touching each other. When you increase the plate separation, what happens to the value of C?
  1.It increases.
  2.It decreases.
  3.It stays the same.



Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

nhea

  • Sr. Member
  • ****
  • Posts: 305
Answer to Question 1

In a series circuit the current is the same in each component.

Answer to Question 2

2




clmills979

  • Member
  • Posts: 551
Reply 2 on: Jul 28, 2018
Excellent


momolu

  • Member
  • Posts: 320
Reply 3 on: Yesterday
Gracias!

 

Did you know?

Malaria was not eliminated in the United States until 1951. The term eliminated means that no new cases arise in a country for 3 years.

Did you know?

According to the CDC, approximately 31.7% of the U.S. population has high low-density lipoprotein (LDL) or "bad cholesterol" levels.

Did you know?

Asthma cases in Americans are about 75% higher today than they were in 1980.

Did you know?

The most destructive flu epidemic of all times in recorded history occurred in 1918, with approximately 20 million deaths worldwide.

Did you know?

Increased intake of vitamin D has been shown to reduce fractures up to 25% in older people.

For a complete list of videos, visit our video library