When checking for proper oil level of a typical manual transmission you will:
a. remove the drain plug and measure the oil that drains out
b. remove the level plug and see if it is at the bottom of the hole
c. remove the level plug and see if it is within an inch of the bottom of the hole d. remove the dipstick and see if it's in the cross hatch area
Question 2
Technician A says vacuum bleeding can be done by a single technician. Technician B says vacuum bleeding may draw air into the system past the bleeder valve. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Schematic of typical plant cell
Structures of a typical cell.
A typical office layout.
A typical waveform of a TP sensor signal as recorded on a DSO when the accelerator pedal was ...
To thoroughly clean a throttle body, it is sometimes best to remove it from the vehicle.
Ice Age Sea Level