When checking for proper oil level of a typical manual transmission you will:
a. remove the drain plug and measure the oil that drains out
b. remove the level plug and see if it is at the bottom of the hole
c. remove the level plug and see if it is within an inch of the bottom of the hole d. remove the dipstick and see if it's in the cross hatch area
Question 2
Technician A says vacuum bleeding can be done by a single technician. Technician B says vacuum bleeding may draw air into the system past the bleeder valve. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Phrases that Decrease Customer Service Level
Visual aids, such as proper walking shoes and a pedometer, or an illustration showing someone ...
Pressure testing the cooling system. A typical hand-operated pressure tester applies pressure equal ...
The fuel level must be above 15% and below 85% before the EVAP monitor will run on most vehicles.
Performing the manual compression test
Transmission of petite phenotypes in Saccharomyces cerevisiae