When checking for proper oil level of a typical manual transmission you will:
a. remove the drain plug and measure the oil that drains out
b. remove the level plug and see if it is at the bottom of the hole
c. remove the level plug and see if it is within an inch of the bottom of the hole d. remove the dipstick and see if it's in the cross hatch area
Question 2
Technician A says vacuum bleeding can be done by a single technician. Technician B says vacuum bleeding may draw air into the system past the bleeder valve. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
A comparison of transmission and scanning electron microscopy
Effective communication and harmony between horse and rider are among the goals of proper training
Typical Organization of the CPT Manual
A typical open-end wrench. Note the size difference on each end and that the head is angled 15 ...
Typical wiring diagram of a V-6 distributorless (direct fire) ignition system.
Ramey's study, children from poverty-level families IQ experiment