Why would 400 SPFM be better that 100 SFPM when carbide cutting ...

[chads108]

Why would 400 SPFM be better that 100 SFPM when carbide cutting tools?
 
  A) Less heat is produced at 400 SFPM than at 100 SFPM
  B) There would be better shaped chips
  C) The higher speed would provide a better finish
  D) The higher speed is less likely to burn the edge of a cutting tool

Question 2

Counterboring is a machining operation where the end of a hole is enlarged in diameter so that a bolt head may be recessed.
 
  Indicate whether the statement is true or false

[sokh]

Answer to Question 1

C

Answer to Question 2

TRUE

[chads108]

YES! Correct, THANKS for helping me on my review

[ryansturges]

Thanks for the timely response, appreciate it