« previous next »

Author Question: The cutting speed (CS) for aluminum is 200 SFPM and the workpiece diameter is 2-1/2 inches. What is ... (Read 60 times)

MGLQZ

  • Hero Member
  • *****
  • Posts: 579
on: Jul 26, 2018
The cutting speed (CS) for aluminum is 200 SFPM and the workpiece diameter is 2-1/2 inches. What is the RPM setting for the lathe? The formula is RPM = CS  4/D:
 
  A) 3200 B) 2000 C) 32 D) 320

Question 2

Copper wire is basically pure copper that has been hardened by:
 
  A) Strain hardening
  B) Precipitation hardening
  C) Alloying with tin and zinc
  D) Heating to 1200 deg. F. (649 deg. C.) and quenching in water


Ashley I

  • Sr. Member
  • ****
  • Posts: 344
Reply #1 on: Jul 26, 2018
Answer to Question 1

D

Answer to Question 2

A


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
« previous next »
 

Did you know?

The first documented use of surgical anesthesia in the United States was in Connecticut in 1844.

Did you know?

There are approximately 3 million unintended pregnancies in the United States each year.

Did you know?

Never take aspirin without food because it is likely to irritate your stomach. Never give aspirin to children under age 12. Overdoses of aspirin have the potential to cause deafness.

Did you know?

When blood is deoxygenated and flowing back to the heart through the veins, it is dark reddish-blue in color. Blood in the arteries that is oxygenated and flowing out to the body is bright red. Whereas arterial blood comes out in spurts, venous blood flows.

Did you know?

Hyperthyroidism leads to an increased rate of metabolism and affects about 1% of women but only 0.1% of men. For most people, this increased metabolic rate causes the thyroid gland to become enlarged (known as a goiter).

Cutting the umbilical cord. Cutting the umbilical cord.
Surgical needle shapes: (A) taper point; (B) cutting point. Surgical needle shapes: (A) taper point; (B) cutting point.
Use caution if using a steel scraper to remove a gasket from aluminum parts. It is best to use a ... Use caution if using a steel scraper to remove a gasket from aluminum parts. It is best to use a ...
The initial timing is where the spark plug fires at idle speed. The computer then advances the ... The initial timing is where the spark plug fires at idle speed. The computer then advances the ...
A scope display showing a normal Chevrolet Equinox MAF sensor at idle speed. the frequency is 2,600 ... A scope display showing a normal Chevrolet Equinox MAF sensor at idle speed. the frequency is 2,600 ...
A tsunami (tidal wave) traveling across deep water can have a speed of 750 km/h k m / h and a ... A tsunami (tidal wave) traveling across deep water can have a speed of 750 km/h k m / h and a ...
Video: Role of ATP in muscle movement

For a complete list of videos, visit our video library