« previous next »

Author Question: The cutting speed (CS) for aluminum is 200 SFPM and the workpiece diameter is 2-1/2 inches. What is ... (Read 70 times)

MGLQZ

  • Hero Member
  • *****
  • Posts: 579
on: Jul 26, 2018
The cutting speed (CS) for aluminum is 200 SFPM and the workpiece diameter is 2-1/2 inches. What is the RPM setting for the lathe? The formula is RPM = CS  4/D:
 
  A) 3200 B) 2000 C) 32 D) 320

Question 2

Copper wire is basically pure copper that has been hardened by:
 
  A) Strain hardening
  B) Precipitation hardening
  C) Alloying with tin and zinc
  D) Heating to 1200 deg. F. (649 deg. C.) and quenching in water


Ashley I

  • Sr. Member
  • ****
  • Posts: 344
Reply #1 on: Jul 26, 2018
Answer to Question 1

D

Answer to Question 2

A


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
« previous next »
 

Did you know?

Vampire bats have a natural anticoagulant in their saliva that permits continuous bleeding after they painlessly open a wound with their incisors. This capillary blood does not cause any significant blood loss to their victims.

Did you know?

The effects of organophosphate poisoning are referred to by using the abbreviations “SLUD” or “SLUDGE,” It stands for: salivation, lacrimation, urination, defecation, GI upset, and emesis.

Did you know?

Vital signs (blood pressure, temperature, pulse rate, respiration rate) should be taken before any drug administration. Patients should be informed not to use tobacco or caffeine at least 30 minutes before their appointment.

Did you know?

In Eastern Europe and Russia, interferon is administered intranasally in varied doses for the common cold and influenza. It is claimed that this treatment can lower the risk of infection by as much as 60–70%.

Did you know?

Lower drug doses for elderly patients should be used first, with titrations of the dose as tolerated to prevent unwanted drug-related pharmacodynamic effects.

The rapid speed of cAMP production The rapid speed of cAMP production
The metric system specifies fasteners by diameter, length, and pitch. The metric system specifies fasteners by diameter, length, and pitch.
A gauge reading with the needle fluctuating 3 to 9 inches Hg below normal often indicates a vacuum ... A gauge reading with the needle fluctuating 3 to 9 inches Hg below normal often indicates a vacuum ...
Find the speed after 40.0 min if the initial speed is 3250 rev/min Find the speed after 40.0 min if the initial speed is 3250 rev/min
Cutting Lamb Noisettes (2 of 2) Cutting Lamb Noisettes (2 of 2)
A pool player is attempting a fancy shot. He hits the cue ball giving it a speed of 5.57 m/s ... A pool player is attempting a fancy shot. He hits the cue ball giving it a speed of 5.57 m/s ...
Video: Nervous pathway to the Neuromuscular (NMJ)

For a complete list of videos, visit our video library