This topic contains a solution. Click here to go to the answer

Author Question: What is the RPM for a 1/4 (.250 ) inch diameter, four flute end mill at a cutting seed of 200 SFPM? ... (Read 112 times)

Lisaclaire

  • Hero Member
  • *****
  • Posts: 569
What is the RPM for a 1/4 (.250 ) inch diameter, four flute end mill at a cutting seed of 200 SFPM?
 
  A) 1200 B) 2200 C) 3200 D) 4200

Question 2

Holes can be drilled on a vertical milling machine by:
 
  A) Using the sensitive quill feed B) Raising the knee of the machine
  C) Using the quill power feed D) All of the above



Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

aliotak

  • Sr. Member
  • ****
  • Posts: 326
Answer to Question 1

C

Answer to Question 2

D




Lisaclaire

  • Member
  • Posts: 569
Reply 2 on: Jul 26, 2018
Wow, this really help


Jsherida

  • Member
  • Posts: 314
Reply 3 on: Yesterday
Gracias!

 

Did you know?

Vaccines cause herd immunity. If the majority of people in a community have been vaccinated against a disease, an unvaccinated person is less likely to get the disease since others are less likely to become sick from it and spread the disease.

Did you know?

Approximately one in four people diagnosed with diabetes will develop foot problems. Of these, about one-third will require lower extremity amputation.

Did you know?

Alcohol acts as a diuretic. Eight ounces of water is needed to metabolize just 1 ounce of alcohol.

Did you know?

After 5 years of being diagnosed with rheumatoid arthritis, one every three patients will no longer be able to work.

Did you know?

About 3.2 billion people, nearly half the world population, are at risk for malaria. In 2015, there are about 214 million malaria cases and an estimated 438,000 malaria deaths.

For a complete list of videos, visit our video library