Waste-spark ignition is being discussed. Technician A says that more voltage is required to fire the compression cylinder than the companion cylinder. Technician B says that waste-spark systems that use compression-sensing electronics do not require a camshaft sensor for engine position. Which technician is correct?
A) Technician A only B) Technician B only
C) Both technicians D) Neither technician
Question 2
The following statements are all correct EXCEPT ________
A) Waste-spark systems use a signal from the PCM once the engine is running.
B) Waste-spark systems do not need a timing signal from the PCM when cranking the engine.
C) No ignition system uses the PCM to control ignition timing.
D) Up-integrated ignition controls use the PCM to control ignition timing.
Forages, such as hay, are required by all horses
A fire safety plan like RACE saves lives.
A CO2 fire extinguisher being used on a fire set in an open drum during a demonstration at a fire ...
A steady but low reading could indicate retarded valve or ignition timing.
This distributor ignition system uses a remotely mounted ignition coil.
How much energy is required to form 141.8 g of Cl2, according to the reaction below? The molar ...