Waste-spark ignition is being discussed. Technician A says that more voltage is required to fire the compression cylinder than the companion cylinder. Technician B says that waste-spark systems that use compression-sensing electronics do not require a camshaft sensor for engine position. Which technician is correct?
A) Technician A only B) Technician B only
C) Both technicians D) Neither technician
Question 2
The following statements are all correct EXCEPT ________
A) Waste-spark systems use a signal from the PCM once the engine is running.
B) Waste-spark systems do not need a timing signal from the PCM when cranking the engine.
C) No ignition system uses the PCM to control ignition timing.
D) Up-integrated ignition controls use the PCM to control ignition timing.
To help locate how far the engine is being rotated, the technician is removing the distributor cap ...
Spark plug wire boot pliers is a handy addition to any tool box.
A worn spark plug showing fuel and/or oil deposits.
Clip-on adapters are used with an ignition system that uses an integral ignition coil.
How much voltage does the resistor drop in Figure 10-2? a. 59 mV b. 19.94 V c. 20 V d. 10 V
During a period of high power demand, the voltage output of the power company is reduced by ...