A chirping noise is heard while the vehicle is moving forward, but stops when the brakes are applied. Technician A says that the noise is likely caused by the disc brake pad wear sensors. Technician B says the noise is likely a wheel bearing because the noise stops when the brakes are applied. Which technician is correct?
A) Technician A only B) Technician B only
C) Both Technicians A and B D) Neither Technician A nor B
Question 2
Technician A says that too much clutch pedal freeplay can cause the clutch to slip during acceleration. Technician B says that too little clutch pedal freeplay can cause the clutch to slip. Which technician is correct?
A) Technician A B) Technician B C) Both technicians D) Neither technician
Range of Motion of the Temporomandibular Joint, Moving the Jaw From Side to Side
A horizontally opposed engine design helps to lower the vehicle’s center of gravity.
Covering the interior as soon as the vehicle comes in for service helps improve customer ...
Start the vehicle’s engine and let run at 1000–1500 RPM. The engine is now running on fuel ...
Lightly squeeze along each finger applying pressure first near the knuckle and then moving along the ...
Effleurage as a finishing and transition technique. Finish the left side with effleurage moving back ...