A chirping noise is heard while the vehicle is moving forward, but stops when the brakes are applied. Technician A says that the noise is likely caused by the disc brake pad wear sensors. Technician B says the noise is likely a wheel bearing because the noise stops when the brakes are applied. Which technician is correct?
A) Technician A only B) Technician B only
C) Both Technicians A and B D) Neither Technician A nor B
Question 2
Technician A says that too much clutch pedal freeplay can cause the clutch to slip during acceleration. Technician B says that too little clutch pedal freeplay can cause the clutch to slip. Which technician is correct?
A) Technician A B) Technician B C) Both technicians D) Neither technician
If raising a vehicle without a frame, place the flat pads under the pinch weld seam to spread the ...
Placard near driver’s door, including what devices in the vehicle contain mercury.
A flex-fuel vehicle often has a yellow gas cap, which is labeled “E85/gasoline”.
Cross-fiber friction to the paraspinal muscles. Friction is created by moving the more superficial ...
Rhythmic compression to gluteal muscles using the fist. Press into the large gluteal muscles moving ...
Apply L strokes, using flat fingers, from temples to edge of mandible. Stretch is forward toward the ...