« previous next »

Author Question: This voltage reading was obtained while cranking the engine. The indicated reading (0.816 V) is ... (Read 237 times)

rayancarla1

  • Hero Member
  • *****
  • Posts: 571
on: Jun 23, 2018
This voltage reading was obtained while cranking the engine. The indicated reading (0.816 V) is _______
  .
 
  A) Too high B) An inconclusive measurement
  C) Too low D) Incorrectly done

Question 2

All of these can cause a starter not to rotate, EXCEPT _________.
 
  A) Seized engine crankshaft B) Defective starter drive
  C) Shorted field coils D) Defective armature


Edwyer

  • Sr. Member
  • ****
  • Posts: 337
Reply #1 on: Jun 23, 2018
Answer to Question 1

A

Answer to Question 2

B


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
« previous next »
 

Did you know?

Essential fatty acids have been shown to be effective against ulcers, asthma, dental cavities, and skin disorders such as acne.

Did you know?

On average, someone in the United States has a stroke about every 40 seconds. This is about 795,000 people per year.

Did you know?

Sperm cells are so tiny that 400 to 500 million (400,000,000–500,000,000) of them fit onto 1 tsp.

Did you know?

In the ancient and medieval periods, dysentery killed about ? of all babies before they reach 12 months of age. The disease was transferred through contaminated drinking water, because there was no way to adequately dispose of sewage, which contaminated the water.

Did you know?

More than 4.4billion prescriptions were dispensed within the United States in 2016.

Cutaway diagram of a four cylinder gasoline engine Cutaway diagram of a four cylinder gasoline engine
An engine will not run if the air–fuel mixture is either too rich or too lean. An engine will not run if the air–fuel mixture is either too rich or too lean.
The high-voltage disconnect switch is in the trunk area on a Toyota Prius. High-voltage lineman’s ... The high-voltage disconnect switch is in the trunk area on a Toyota Prius. High-voltage lineman’s ...
After the engine has been cranked for four “puffs,” stop cranking the engine and observe the ... After the engine has been cranked for four “puffs,” stop cranking the engine and observe the ...
Using a scan tool to check battery voltage. Using a scan tool to check battery voltage.
When the O2S voltage rises above 450 mV, the PCM starts to control the fuel mixture based on ... When the O2S voltage rises above 450 mV, the PCM starts to control the fuel mixture based on ...
Video: Resting membrane potential - electrical polarity and maintenance requirements

For a complete list of videos, visit our video library