« previous next »

Author Question: This voltage reading was obtained while cranking the engine. The indicated reading (0.816 V) is ... (Read 211 times)

rayancarla1

  • Hero Member
  • *****
  • Posts: 571
on: Jun 23, 2018
This voltage reading was obtained while cranking the engine. The indicated reading (0.816 V) is _______
  .
 
  A) Too high B) An inconclusive measurement
  C) Too low D) Incorrectly done

Question 2

All of these can cause a starter not to rotate, EXCEPT _________.
 
  A) Seized engine crankshaft B) Defective starter drive
  C) Shorted field coils D) Defective armature


Edwyer

  • Sr. Member
  • ****
  • Posts: 337
Reply #1 on: Jun 23, 2018
Answer to Question 1

A

Answer to Question 2

B


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
« previous next »
 

Did you know?

It is important to read food labels and choose foods with low cholesterol and saturated trans fat. You should limit saturated fat to no higher than 6% of daily calories.

Did you know?

The strongest synthetic topical retinoid drug available, tazarotene, is used to treat sun-damaged skin, acne, and psoriasis.

Did you know?

More than 20 million Americans cite use of marijuana within the past 30 days, according to the National Survey on Drug Use and Health (NSDUH). More than 8 million admit to using it almost every day.

Did you know?

In most climates, 8 to 10 glasses of water per day is recommended for adults. The best indicator for adequate fluid intake is frequent, clear urination.

Did you know?

Atropine was named after the Greek goddess Atropos, the oldest and ugliest of the three sisters known as the Fates, who controlled the destiny of men.

Cutaway diagram of a four cylinder gasoline engine Cutaway diagram of a four cylinder gasoline engine
Are the resutls from the glucose strip test consistent with the results obtained from the ... Are the resutls from the glucose strip test consistent with the results obtained from the ...
The bore and stroke of pistons are used to calculate an engine’s displacement. The bore and stroke of pistons are used to calculate an engine’s displacement.
If the gauge reading is now much higher than the first test results, then the cause of the low ... If the gauge reading is now much higher than the first test results, then the cause of the low ...
Be sure that the clips are properly installed. Start the engine and check for proper operation. Be sure that the clips are properly installed. Start the engine and check for proper operation.
Start the fuel injector cleaning process by bringing the vehicle’s engine up to operating ... Start the fuel injector cleaning process by bringing the vehicle’s engine up to operating ...
Video: HDL (high density lipoprotein)

For a complete list of videos, visit our video library