This topic contains a solution. Click here to go to the answer

Author Question: When making GTAW V-groove welds on aluminum plate with backing in the 1G position, the work angle ... (Read 110 times)

fagboi

  • Hero Member
  • *****
  • Posts: 535
When making GTAW V-groove welds on aluminum plate with backing in the 1G position, the work angle
  for the root pass should be _____.
 
  a. 0 degrees
  b. 10 degrees
  c. 15 to 20 degrees
  d. 25 to 30 degrees

Question 2

The most dangerous fuel gas, due to its ability to ignite in low concentrations with air, is _____.
 
  a. argon
  b. helium
  c. propane
  d. acetylene



Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

chevyboi1976

  • Sr. Member
  • ****
  • Posts: 344
Answer to Question 1

a

Answer to Question 2

d



fagboi

  • Hero Member
  • *****
  • Posts: 535
Both answers were spot on, thank you once again




 

Did you know?

Human kidneys will clean about 1 million gallons of blood in an average lifetime.

Did you know?

The average adult has about 21 square feet of skin.

Did you know?

The National Institutes of Health have supported research into acupuncture. This has shown that acupuncture significantly reduced pain associated with osteoarthritis of the knee, when used as a complement to conventional therapies.

Did you know?

Interferon was scarce and expensive until 1980, when the interferon gene was inserted into bacteria using recombinant DNA technology, allowing for mass cultivation and purification from bacterial cultures.

Did you know?

Glaucoma is a leading cause of blindness. As of yet, there is no cure. Everyone is at risk, and there may be no warning signs. It is six to eight times more common in African Americans than in whites. The best and most effective way to detect glaucoma is to receive a dilated eye examination.

For a complete list of videos, visit our video library