An air conditioner with a thermostatic expansion valve is operating with a condenser saturation temperature of 110F and a liquid-line temperature of 85F. The factory-specified subcooling for the current operating condition is 10F. After checking the condenser coil and airflow, the technician should:
A) Add charge because the system is undercharged.
B) Leave the charge alone because it is cooling even better than factory specifications.
C) Move some of the charge from the low side of the system to the high side of the system to balance the charge.
D) Recover charge because the system is overcharged.
Question 2
Capacitance meters measure the capacitance in a circuit or in a start capacitor. This is measured in what unit?
A) Amps B) Ohms C) Microfarads D) Volts
Chrysler also recommends that a clear plastic hose (1/4" ID) be attached to the bleeder valve ...
Adjusting a valve takes both hands—one to hold the wrench to loosen and tighten the lock nut and ...
An EGR valve position sensor on top of an EGR valve.
Palpation for respiratory expansion
When operating your own business, it is wise to know your cost of capital and that of the ...
Rapidly decreasing sequence costs have enabled the rapid expansion