« previous next »

Author Question: What is a deburring tool used for? What will be an ideal ... (Read 24 times)

crobinson2013

  • Hero Member
  • *****
  • Posts: 535
on: Jul 26, 2018
What is a deburring tool used for?
 
  What will be an ideal response?

Question 2

Explain the technique that should be used when using an adjustable wrench.
 
  What will be an ideal response?


dajones82

  • Sr. Member
  • ****
  • Posts: 359
Reply #1 on: Jul 26, 2018
Answer to Question 1

Pipe cutters leave a small burr inside the cut end of pipe and tubes. This burr must be removed.

Answer to Question 2

Always use this type of wrench in a manner such that the force is in a down or clockwise direction with the movable jaw on the bottom when tightening a bolt.


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
« previous next »
 

Did you know?

Approximately one in four people diagnosed with diabetes will develop foot problems. Of these, about one-third will require lower extremity amputation.

Did you know?

Russia has the highest death rate from cardiovascular disease followed by the Ukraine, Romania, Hungary, and Poland.

Did you know?

Cytomegalovirus affects nearly the same amount of newborns every year as Down syndrome.

Did you know?

In 1885, the Lloyd Manufacturing Company of Albany, New York, promoted and sold "Cocaine Toothache Drops" at 15 cents per bottle! In 1914, the Harrison Narcotic Act brought the sale and distribution of this drug under federal control.

Did you know?

In ancient Rome, many of the richer people in the population had lead-induced gout. The reason for this is unclear. Lead poisoning has also been linked to madness.

Cultures Ideal Body Types Cultures Ideal Body Types
An exhaust manifold spreader tool is a tool that is absolutely necessary to use when reinstalling ... An exhaust manifold spreader tool is a tool that is absolutely necessary to use when reinstalling ...
After connecting the shutoff tool, start the engine and operate all accessories. Stop the engine ... After connecting the shutoff tool, start the engine and operate all accessories. Stop the engine ...
Using a scan tool to check for IAC counts or percentage as part of a diagnostic routine. Using a scan tool to check for IAC counts or percentage as part of a diagnostic routine.
A backpressure tool can be made by using an oxygen sensor housing and using epoxy or braze to hold ... A backpressure tool can be made by using an oxygen sensor housing and using epoxy or braze to hold ...
For the circuit in Figure 1, assume ideal diodes. The peak inverse voltage is approximately For the circuit in Figure 1, assume ideal diodes. The peak inverse voltage is approximately
Video: Kinetic parameters & Kinetic experiment

For a complete list of videos, visit our video library