[Answered] A right angle milling attachment: A) Is used in hard to reach places on a workpiece B) Makes ...

This topic contains a solution. Click here to go to the answer

Author Question: A right angle milling attachment: A) Is used in hard to reach places on a workpiece B) Makes ... (Read 54 times)

sabina

Hero Member
Posts: 563

on: Jul 26, 2018

A right angle milling attachment:

A) Is used in hard to reach places on a workpiece B) Makes possible the milling of internal slots
C) Can be used to cut slots at different angles D) All of the above

Question 2

Angular cuts on workpieces can be made:

A) By tilting the workpiece B) With the peripheral teeth of an end mill
C) By tilting the work head D) All of the above

Need homework help now?

Ask unlimited questions for free

Ask a Question

Marked as best answer by a Subject Expert

mmpiza

Sr. Member
Posts: 354

Reply #1 on: Jul 26, 2018

Answer to Question 1

D

Answer to Question 2

D

sabina

Hero Member
Posts: 563

Reply #2 on: Jul 26, 2018

Thanks

mmpiza

Sr. Member
Posts: 354

Reply #3 on: Jul 26, 2018

Welcome

« previous next »

Did you know?

Before a vaccine is licensed in the USA, the Food and Drug Administration (FDA) reviews it for safety and effectiveness. The CDC then reviews all studies again, as well as the American Academy of Pediatrics and the American Academy of Family Physicians. Every lot of vaccine is tested before administration to the public, and the FDA regularly inspects vaccine manufacturers' facilities.

Did you know?

Intradermal injections are somewhat difficult to correctly administer because the skin layers are so thin that it is easy to accidentally punch through to the deeper subcutaneous layer.

Did you know?

As of mid-2016, 18.2 million people were receiving advanced retroviral therapy (ART) worldwide. This represents between 43–50% of the 34–39.8 million people living with HIV.

Did you know?

More than 30% of American adults, and about 12% of children utilize health care approaches that were developed outside of conventional medicine.

Did you know?

The first oncogene was discovered in 1970 and was termed SRC (pronounced "SARK").

Insert the needle with the beveled side up. Keep the angle low, 10 to 30 degrees.

Darwin observed that tortoises on islands that are arid tend to have saddle-shaped shells, allowing

Locating angle of louis

The hard palate is located anteriorly in the roof of the mouth

Attachment and cell entry by HIV.

Names for Places from Millions to Millionths

Author Question: A right angle milling attachment: A) Is used in hard to reach places on a workpiece B) Makes ... (Read 54 times)

Related Topics

Need homework help now?