« previous next »

Author Question: Which of the following is the correct RPM for drilling a 1.000 inch diameter hole in SAE 4140 if the ... (Read 76 times)

mikaylakyoung

  • Hero Member
  • *****
  • Posts: 531
on: Jul 26, 2018
Which of the following is the correct RPM for drilling a 1.000 inch diameter hole in SAE 4140 if the CS is 50 SFPM?
 
  A) 25 B) 160 C) 250 D) 1600

Question 2

Which cutting fluid would be be best for reaming or tapping low carbon steel?
 
  A) Kerosene B) Lubricating oil C) Soluble oil D) Sulfurized oil


Brummell1998

  • Sr. Member
  • ****
  • Posts: 324
Reply #1 on: Jul 26, 2018
Answer to Question 1

C

Answer to Question 2

D


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
« previous next »
 

Did you know?

A seasonal flu vaccine is the best way to reduce the chances you will get seasonal influenza and spread it to others.

Did you know?

Approximately one in three babies in the United States is now delivered by cesarean section. The number of cesarean sections in the United States has risen 46% since 1996.

Did you know?

Always store hazardous household chemicals in their original containers out of reach of children. These include bleach, paint, strippers and products containing turpentine, garden chemicals, oven cleaners, fondue fuels, nail polish, and nail polish remover.

Did you know?

In most cases, kidneys can recover from almost complete loss of function, such as in acute kidney (renal) failure.

Did you know?

As many as 20% of Americans have been infected by the fungus known as Histoplasmosis. While most people are asymptomatic or only have slight symptoms, infection can progress to a rapid and potentially fatal superinfection.

Great Blue Hole of Belize Great Blue Hole of Belize
The correct beginning position for the patient’s feet and crutches (tripod position). The correct beginning position for the patient’s feet and crutches (tripod position).
A typical battery-powered 3/8 inch drive impact wrench. A typical battery-powered 3/8 inch drive impact wrench.
A track inside an ignition coil is not a short, but rather it is a low-resistance path or hole that ... A track inside an ignition coil is not a short, but rather it is a low-resistance path or hole that ...
To test for a leak, this tester was set to the 0.020 inch hole and turned on. The ball rose in the ... To test for a leak, this tester was set to the 0.020 inch hole and turned on. The ball rose in the ...
Using the measuring device to give the correct dose to children Using the measuring device to give the correct dose to children
Video: Electrical changes in the heart

For a complete list of videos, visit our video library