This topic contains a solution. Click here to go to the answer
« previous next »

Author Question: C-clamps are mostly used by machinists for: A) Clamping workpieces on machines such as drill ... (Read 50 times)

Zoey63294

  • Hero Member
  • *****
  • Posts: 539
on: Jul 26, 2018
C-clamps are mostly used by machinists for:
 
  A) Clamping workpieces on machines such as drill presses
  B) Clamping workpieces on the bench for filing and sawing
  C) Holding delicate measuring and layout setups
  D) Holding vises on milling machines and shapers

Question 2

What two important things should be done before pressing in a bushing?
 
  A) Clean all the oil off the bushing and wash your hands so you won't get contaminated
  B) Oil the bushing and start it in the bore with a hammer before you start pressing
  C) Chamfer and lubricate the bore
  D) None of the above


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

essyface1

  • Sr. Member
  • ****
  • Posts: 347
Reply #1 on: Jul 26, 2018
Answer to Question 1

A

Answer to Question 2

C


Zoey63294

  • Member
  • Posts: 539
Reply 2 on: Jul 26, 2018
:D TYSM

JaynaD87

  • Member
  • Posts: 368
Reply 3 on: Yesterday
YES! Correct, THANKS for helping me on my review

« previous next »
 

Did you know?

As the western states of America were settled, pioneers often had to drink rancid water from ponds and other sources. This often resulted in chronic diarrhea, causing many cases of dehydration and death that could have been avoided if clean water had been available.

Did you know?

Sperm cells are so tiny that 400 to 500 million (400,000,000–500,000,000) of them fit onto 1 tsp.

Did you know?

More than 30% of American adults, and about 12% of children utilize health care approaches that were developed outside of conventional medicine.

Did you know?

In Eastern Europe and Russia, interferon is administered intranasally in varied doses for the common cold and influenza. It is claimed that this treatment can lower the risk of infection by as much as 60–70%.

Did you know?

Pubic lice (crabs) are usually spread through sexual contact. You cannot catch them by using a public toilet.

An Oil Exploration Drill Site An Oil Exploration Drill Site
This girl ran four spinning machines in a cotton mill in Whitnel, North Carolina. Only 4 feet, 3 inc This girl ran four spinning machines in a cotton mill in Whitnel, North Carolina. Only 4 feet, 3 inc
A recruit with a drill instructor. A recruit with a drill instructor.
Inline fuel filters are usually attached to the fuel line with screw clamps or threaded ... Inline fuel filters are usually attached to the fuel line with screw clamps or threaded ...
Wages and Machines in the Textile Industry, 1910 Wages and Machines in the Textile Industry, 1910
Portable X Ray machines. Portable X Ray machines.
Video: Introduction to filtration - filtrate formation and composition

For a complete list of videos, visit our video library