The cutting speed for carbide tools is normally three to four ...

[jman1234]

The cutting speed for carbide tools is normally three to four times higher than high-speed cutting tools.
 
  Indicate whether the statement is true or false

Question 2

The amount of pressure you should apply to a bushing in an arbor press would be:
 
  A) Just the amount needed to push it through the bore and when slight additional pressure is felt, stop pressing
  B) About 5 tons
  C) Just the amount needed to push it through the bore and then considerable more force applied to make sure it is seated
  D) Between 10 and 30 tons

[xoxo123]

Answer to Question 1

TRUE

Answer to Question 2

A

[jman1234]

Thank you!

[xoxo123]

Always glad to help...