« previous next »

Author Question: The cutting speed for carbide tools is normally three to four times higher than high-speed cutting ... (Read 94 times)

jman1234

  • Hero Member
  • *****
  • Posts: 560
on: Jul 26, 2018
The cutting speed for carbide tools is normally three to four times higher than high-speed cutting tools.
 
  Indicate whether the statement is true or false

Question 2

The amount of pressure you should apply to a bushing in an arbor press would be:
 
  A) Just the amount needed to push it through the bore and when slight additional pressure is felt, stop pressing
  B) About 5 tons
  C) Just the amount needed to push it through the bore and then considerable more force applied to make sure it is seated
  D) Between 10 and 30 tons


xoxo123

  • Sr. Member
  • ****
  • Posts: 335
Reply #1 on: Jul 26, 2018
Answer to Question 1

TRUE

Answer to Question 2

A


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question

jman1234

  • Hero Member
  • *****
  • Posts: 560
Reply #2 on: Jul 26, 2018
Thank you!


xoxo123

  • Sr. Member
  • ****
  • Posts: 335
Reply #3 on: Jul 26, 2018
Always glad to help...


« previous next »
 

Did you know?

Since 1988, the CDC has reported a 99% reduction in bacterial meningitis caused by Haemophilus influenzae, due to the introduction of the vaccine against it.

Did you know?

Barbituric acid, the base material of barbiturates, was first synthesized in 1863 by Adolph von Bayer. His company later went on to synthesize aspirin for the first time, and Bayer aspirin is still a popular brand today.

Did you know?

In most cases, kidneys can recover from almost complete loss of function, such as in acute kidney (renal) failure.

Did you know?

In Eastern Europe and Russia, interferon is administered intranasally in varied doses for the common cold and influenza. It is claimed that this treatment can lower the risk of infection by as much as 60–70%.

Did you know?

People who have myopia, or nearsightedness, are not able to see objects at a distance but only up close. It occurs when the cornea is either curved too steeply, the eye is too long, or both. This condition is progressive and worsens with time. More than 100 million people in the United States are nearsighted, but only 20% of those are born with the condition. Diet, eye exercise, drug therapy, and corrective lenses can all help manage nearsightedness.

A typical module-controlled high-side driver (HSD) where the module itself supplies the electrical ... A typical module-controlled high-side driver (HSD) where the module itself supplies the electrical ...
A scope display showing a normal Chevrolet Equinox MAF sensor at idle speed. the frequency is 2,600 ... A scope display showing a normal Chevrolet Equinox MAF sensor at idle speed. the frequency is 2,600 ...
Histopathologic findings in Crohn's disease. A high magnification micrograph of a colonic ... Histopathologic findings in Crohn's disease. A high magnification micrograph of a colonic ...
Permafrost: High albedo, reflects as much as 90% of the Sun’s energy Permafrost: High albedo, reflects as much as 90% of the Sun’s energy
Effect of dietary fats on high- and low-density cholesterol levels Effect of dietary fats on high- and low-density cholesterol levels
At what speed does Grogzetti need to take the curve to avoid sliding? At what speed does Grogzetti need to take the curve to avoid sliding?
Video: Bone cells and tissues - tissue composition and cells

For a complete list of videos, visit our video library