« previous next »

Author Question: What is the current across the LSB rung of a 4-bit R/2R Ladder DAC if the reference voltage is 4 V ... (Read 45 times)

ahriuashd

  • Hero Member
  • *****
  • Posts: 535
on: Jul 28, 2018
What is the current across the LSB rung of a 4-bit R/2R Ladder DAC if the reference voltage is 4 V and R is 5 k?
 
  A) 125 A B) 250 A C) 100 A D) 50 A

Question 2

What will be the change in bits of the ADC output?
 
  A) 3 bits B) 8 bits C) 2 bits D) 1 bit


kristenb95

  • Sr. Member
  • ****
  • Posts: 318
Reply #1 on: Jul 28, 2018
Answer to Question 1

D

Answer to Question 2

D


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
« previous next »
 

Did you know?

Chronic marijuana use can damage the white blood cells and reduce the immune system's ability to respond to disease by as much as 40%. Without a strong immune system, the body is vulnerable to all kinds of degenerative and infectious diseases.

Did you know?

Less than one of every three adults with high LDL cholesterol has the condition under control. Only 48.1% with the condition are being treated for it.

Did you know?

The most dangerous mercury compound, dimethyl mercury, is so toxic that even a few microliters spilled on the skin can cause death. Mercury has been shown to accumulate in higher amounts in the following types of fish than other types: swordfish, shark, mackerel, tilefish, crab, and tuna.

Did you know?

Famous people who died from poisoning or drug overdose include, Adolf Hitler, Socrates, Juan Ponce de Leon, Marilyn Monroe, Judy Garland, and John Belushi.

Did you know?

More than 4.4billion prescriptions were dispensed within the United States in 2016.

Voltmeter showing the battery voltage when the headlights were on (engine off) for one minute. Voltmeter showing the battery voltage when the headlights were on (engine off) for one minute.
MAP sensors use three wires: 1.5 volt reference from the PCM 2. Sensor signal (output signal) 3. ... MAP sensors use three wires: 1.5 volt reference from the PCM 2. Sensor signal (output signal) 3. ...
To check for voltage at terminal 30, use a test light or a voltmeter. Start by connecting the ... To check for voltage at terminal 30, use a test light or a voltmeter. Start by connecting the ...
The first step in the reprogramming procedure is to determine the current software installed using a ... The first step in the reprogramming procedure is to determine the current software installed using a ...
Write the equation for the voltage at any instant, and find the voltage at 4.0 s Write the equation for the voltage at any instant, and find the voltage at 4.0 s
A rigid circular loop has a radius of 0.20 m and is in the xy-plane. A clockwise current I is ... A rigid circular loop has a radius of 0.20 m and is in the xy-plane. A clockwise current I is ...
Video: Phases of an Action Potential - Resting Potential, Threshold, Rising, Falling, & Recovery Phases

For a complete list of videos, visit our video library