[Answered] Why is the pin CS on an ADC connected to the ground? A) so that the chip is always Reset B) so ...

This topic contains a solution. Click here to go to the answer

Author Question: Why is the pin CS on an ADC connected to the ground? A) so that the chip is always Reset B) so ... (Read 43 times)

dejastew

Hero Member
Posts: 562

on: Jul 28, 2018

Why is the pin CS on an ADC connected to the ground?

A) so that the chip is always Reset B) so that the chip is always activated
C) so that the chip is always deactivated D) so that the chip is always LOW

Question 2

What is the conversion speed for an ADC?

A) 10 s B) 10 ms C) 20 s D) 20 ms

Need homework help now?

Ask unlimited questions for free

Ask a Question

Marked as best answer by a Subject Expert

kkenney

Sr. Member
Posts: 352

Reply #1 on: Jul 28, 2018

Answer to Question 1

B

Answer to Question 2

D

dejastew

Hero Member
Posts: 562

Reply #2 on: Jul 28, 2018

Thanks

kkenney

Sr. Member
Posts: 352

Reply #3 on: Jul 28, 2018

Welcome

« previous next »

Did you know?

The FDA recognizes 118 routes of administration.

Did you know?

The average office desk has 400 times more bacteria on it than a toilet.

Did you know?

Nitroglycerin is used to alleviate various heart-related conditions, and it is also the chief component of dynamite (but mixed in a solid clay base to stabilize it).

Did you know?

Hip fractures are the most serious consequences of osteoporosis. The incidence of hip fractures increases with each decade among patients in their 60s to patients in their 90s for both women and men of all populations. Men and women older than 80 years of age show the highest incidence of hip fractures.

Did you know?

Carbamazepine can interfere with the results of home pregnancy tests. If you are taking carbamazepine, do not try to test for pregnancy at home.

Great apes knuckle-walk when traveling on the ground.

Drive-on ramps are dangerous to use. The wheels on the ground level must be chocked (blocked) to ...

A conventional zirconia oxygen sensor can only reset to exhaust mixtures that are richer or leaner ...

A view of a typical filler tube with the fuel tank removed. Notice the ground strap used to help ...

The throttle pedal is connected to the accelerator pedal position (APP) sensor. The electronic ...

A reverse-biased silicon diode is connected in series with a 12 V source and a resistor.The ...

Author Question: Why is the pin CS on an ADC connected to the ground? A) so that the chip is always Reset B) so ... (Read 43 times)

Related Topics

Need homework help now?