This topic contains a solution. Click here to go to the answer

Author Question: Why is the pin CS on an ADC connected to the ground? A) so that the chip is always Reset B) so ... (Read 38 times)

dejastew

  • Hero Member
  • *****
  • Posts: 562
Why is the pin CS on an ADC connected to the ground?
 
  A) so that the chip is always Reset B) so that the chip is always activated
  C) so that the chip is always deactivated D) so that the chip is always LOW

Question 2

What is the conversion speed for an ADC?
 
  A) 10 s B) 10 ms C) 20 s D) 20 ms



Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

kkenney

  • Sr. Member
  • ****
  • Posts: 352
Answer to Question 1

B

Answer to Question 2

D





 

Did you know?

Approximately one in three babies in the United States is now delivered by cesarean section. The number of cesarean sections in the United States has risen 46% since 1996.

Did you know?

According to the CDC, approximately 31.7% of the U.S. population has high low-density lipoprotein (LDL) or "bad cholesterol" levels.

Did you know?

Despite claims by manufacturers, the supplement known as Ginkgo biloba was shown in a study of more than 3,000 participants to be ineffective in reducing development of dementia and Alzheimer’s disease in older people.

Did you know?

The average adult has about 21 square feet of skin.

Did you know?

According to the National Institute of Environmental Health Sciences, lung disease is the third leading killer in the United States, responsible for one in seven deaths. It is the leading cause of death among infants under the age of one year.

For a complete list of videos, visit our video library