Answer to Question 1
B
Answer to Question 2
Screws should be used rather than nails, 12 inches o.c. on ceilings, 16 o.c. on walls. If framing members are 24 inches o.c., screws should be placed maximum of 12 inches o.c.
Thorough inspection of studs should be made before application of gypsum board, and warped studs should be replaced.
After all sheets are installed, outside corners are protected by a metal corner or bead, which provides resistance to edge cracking and chipping.
Joint cement, spackling compound (mud) is applied to all joints with a 5 wide spackling knife. Tape is placed over joint and pressed into mud.
Outside beads have joint cement feathered to meet the edge. Another layer of mud is applied, and outer edges are feathered.
After drying, mud is sanded; third coat applied, extending feathering beyond previous coats. Screw holes are filled with mud and sanded smooth.
The surface may be left smooth, ready for painting or wallcovering, or may have a texture appliedorange peel, skip-troweled, or heavily stippled finishtexture helps hide surface imperfections.
The Real Reason Why They Repeat the Same 20 Songs on the Radio & TV Nationwide
Dominance relationships among individuals play an important role in many primate societies.
The world has been horrified recently at a U.S. Congress so polarized and paralyzed that it cannot p
Figure 7.1 shows the rapid decline in the trust of Americans in government since the 1960s. This de
Respirator decision logic based on the EPA method. It is very important to know when to use supplied ...
Red, fleshy fruits of hawthorn plants (Crataegus) are an important food for cedar waxwings (Bombycil