« previous next »

Author Question: The cutting speed (CS) for aluminum is 200 SFPM and the workpiece diameter is 2-1/2 inches. What is ... (Read 32 times)

MGLQZ

  • Hero Member
  • *****
  • Posts: 579
on: Jul 26, 2018
The cutting speed (CS) for aluminum is 200 SFPM and the workpiece diameter is 2-1/2 inches. What is the RPM setting for the lathe? The formula is RPM = CS  4/D:
 
  A) 3200 B) 2000 C) 32 D) 320

Question 2

Copper wire is basically pure copper that has been hardened by:
 
  A) Strain hardening
  B) Precipitation hardening
  C) Alloying with tin and zinc
  D) Heating to 1200 deg. F. (649 deg. C.) and quenching in water


Ashley I

  • Sr. Member
  • ****
  • Posts: 344
Reply #1 on: Jul 26, 2018
Answer to Question 1

D

Answer to Question 2

A


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
« previous next »
 

Did you know?

Human kidneys will clean about 1 million gallons of blood in an average lifetime.

Did you know?

The calories found in one piece of cherry cheesecake could light a 60-watt light bulb for 1.5 hours.

Did you know?

The most destructive flu epidemic of all times in recorded history occurred in 1918, with approximately 20 million deaths worldwide.

Did you know?

The term bacteria was devised in the 19th century by German biologist Ferdinand Cohn. He based it on the Greek word "bakterion" meaning a small rod or staff. Cohn is considered to be the father of modern bacteriology.

Did you know?

Illicit drug use costs the United States approximately $181 billion every year.

Forest fragments left by clear-cutting forest from the surrounding landscape have very different phy Forest fragments left by clear-cutting forest from the surrounding landscape have very different phy
This girl ran four spinning machines in a cotton mill in Whitnel, North Carolina. Only 4 feet, 3 inc This girl ran four spinning machines in a cotton mill in Whitnel, North Carolina. Only 4 feet, 3 inc
Stronger threads are created by cold rolling a heat-treated bolt blank instead of cutting the ... Stronger threads are created by cold rolling a heat-treated bolt blank instead of cutting the ...
An oscillating needle 1 or 2 inches Hg below normal could indicate an incorrect air–fuel mixture ... An oscillating needle 1 or 2 inches Hg below normal could indicate an incorrect air–fuel mixture ...
Thin disk specimens of aluminum oxide Thin disk specimens of aluminum oxide
A 4.0-kg block slides down a 35 incline at a constant speed when a 16-N force is applied acting ... A 4.0-kg block slides down a 35 incline at a constant speed when a 16-N force is applied acting ...
Video: hGH, Thyroid hormones & Aldosterone

For a complete list of videos, visit our video library