Technician A says that the pitman arm is connected to the steering gear. Technician B says that an idler arm is used with all rack and pinion steering linkages. Which technician is correct?
A) Technician A only B) Technician B only
C) Both technicians A and B D) Neither technician A nor B
Question 2
New tie rods are being installed. Technician A says to tighten the retaining nuts to specification and then loosen, if needed, to align the cotter pin hole. Technician B says to tighten farther to align the cotter key hole. Which technician is correct?
A) Technician A only B) Technician B only
C) Both technicians A and B D) Neither technician A nor B
Major trunk lines carrying long-distance traffic crisscrossed the area east of the Mississippi. The
A technician-made adapter used to test exhaust system back pressure.
Some ignition coils are electrically connected, called married (top figure), whereas others use ...
To measure fuel-injector resistance, a technician constructed a short wiring harness with a double ...
A spark tester connected to a spark plug wire or coil output. A typical spark tester will fire only ...
After checking for stored diagnostic trouble codes (DTCs), the wise technician checks service ...